In nearly all situations, most individuals spend quite a lot of money purchasing their forklift. Thus, it is very important to take good care of it so as to protect your investment well into the long run. It is a good idea to know the procedures which are undertaken during maintaining and taking care of this machine.
By starting up the forklift and listening carefully how it works is one of the best ways to tell how good the engine is running. For instance, if there are any misses or knocks, the equipment is defective and this must raise several concerns. In addition listen closely for any squealing noise which come from the belts as these sounds would provide you with a lot of information.
When carrying out maintenance, several of the main components you will have to pay attention to include the horn, safety warning devices, the lights, the gauges and the overhead guard. Any faulty parts or burnt out light bulbs must be replaced as soon as they are noticed. It is also essential to check the wiring.
The battery compartment terminals must be cleaned after the above parts have been inspected thoroughly. If the terminals are not clean, be sure to clean them properly. Each and every cell of the battery has to be checked so as to make certain that the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machine and after that change the filters. The hydraulic filter, the transmission filter and the fuel filters must be regularly replaced. Before fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
When the oil change has been done and new filters have been fitted, visually check the drive axle from underneath the machine. Be certain to grease the axle if there is any grease fitting. Inspect the engine belts for any cracks or frays. If you find any, fix the issue accordingly. Afterwards, check every other part of the equipment including the wheels. If any kind of issue or fault is detected, be certain to address it immediately so as to make sure the machinery is running at its safest and optimum levels.