It is important to utilize extra caution when using a rough terrain scissor lift. Drivers should be completely aware of the surrounding environment. Long booms on the equipment act as levers from the center of the drive unit. Like for instance, a 6 inch bump can cause a 3 foot bounce when the driver is at the driver controls. Consider all other traffic nearby, because they might not know that you are moving. Plan your assent carefully. Park the boom lift on a flat surface which has no water or mud. These areas cover deep potholes that can be potentially cause the occupants to fall if the tires fell into the holes. If provided, use all of the outriggers, completely extended. Be certain to just use wooden chalk blocks that are approved.
Many lifts operate from a metal platform on the end of the boom. The extended booms act as levers from the drive unit's center. A 6-inch bump could cause a 3-foot bounce while you are at the driver controls. Be aware of all other traffic. They may not be aware that you are moving. Plan your assent. Park the boom lift on a flat surface free of any mud or water. These areas could cover deep potholes in which the lift tires could fall, tipping the occupants. Extend all outriggers, if provided, completely. Place just approved wooden chalk blocks under the outrigger pads to prevent the unit from moving.
Overhead power lines are a serious danger for lift drivers no matter what lift is being utilized. For example, if the driver of the platform is not being aware, or if the platform is being controlled by ground personnel that could not accurately access proximity to wiring and thus, either the platform itself or the worker can be easily brought into contact with electrical wires. The employee can be electrocuted unfortunately unless correctly insulated.