Inspect a Forklift
There are over 10,000 workplace injuries connected to forklifts happen every year, according to OSHA and HRSDC reports. Many of these accidents are caused by driver error. Lack of proper equipment check and maintenance causes many others. Operation and maintenance of a forklift is not only the cause of personal injuries, but also of damage to property. Forklifts can damage sprinklers, building structures and overhead pipes, and other machinery when utilized improperly. The following day by day inspections must be done so as to lessen the chance of forklift mishaps.
Turn the engine off prior to checking various fluid levels: fuel, engine oil, hydraulic oil, coolant and brake fluid. The tires must be checked for signs of wear and tear. Check the air pressure in the tires. Check the condition of the forks. The load backrest should be attached tightly. Do a visual inspection of the top-clip retaining heel and pin. Next perform an inspection of the mast chains, hydraulic hoses, stops and cables. Make sure that the overhead and finger guards are attached securely.
The LP fueled forklift has propane tanks that need to be checked for corrosion, damage or rust. The battery's charge and electrolyte levels need to be tested periodically. Seat belts need to be inspected for wear and tear. Check to make certain the owner's guidebook is stored on-board the forklift in a storage compartment. Check the seat belt to make certain the latches are secure. Test the hood latch to make sure that it is working as it should.
Start the forklift and listen to the noise of the engine to make sure there are no unusual sounds. If there are, investigate promptly. Check the accelerator and the steering controls. The parking break and the service break should be properly working.
To guarantee proper functioning in both reverse and forward, the drive control and tilt control must be inspected. The functioning of the lowering control, the hoist and attachment control requires periodic inspection. Check the horn and lights. After that check the defroster, wipers and heater to make sure they are working smoothly. Check every gauge to ascertain that it is reading within functional limits.